FIRE FIGHTING
COMPLIANCE WITH REGULATION:
SELECT ONE

SCF8C-J-AS

Controller for Jacking Pumps

SCF8C-J-AS
Ask for quotation
SCF8C-J-AS

Controllers for  electric Jacking Pumps 

SCF8C-J-AS controllers; High specification,  user friendly and configurable instruments;  They are useful for automatically operate single or three-phase Jacking pumps in any environment

SCF8C-J-AS controllers automatically start and stop Jacking  pumps depending on the system’s demand; protect them by means of the connected and controller-generated alarms, visualize the most relevant values and informations, also manage the communication of the operator and both the contour elements and the remoted manned centre.

MAIN FEATURES: SCF8C-J-AS

Electric Jacking  Pumps controllers: AS 2941

  • Nº STANDARDS & TECHNICAL RULES
    1 Australian Standard AS 2841-13
    2 Australian Standard AS/NZS 3000:2007
  • Nº RANGE OF MODELS (according to the type plate)
    1 Incoming line voltage 400 V AC / 230 V AC
    2 Mains frequency 50Hz / 60Hz.
    3 Jockey pump motor size Up to 7,5 kW or 2,2kW
    4 Motor starter type Direct (DOL)
  • Nº CONSTRUCTIVE FEATURES
    1 External enclosure IP65 Protected from total dust ingress (NEMA 4)
    2 Impact rating: IK10 (except for display)
    3 Fireproof grade: Fire extinguishes <30s
    4 Display Transflective: Visible under direct sunlight
    5 Wiring Halogen free
    6 Fireproof: RZ1 according to EN50200 (830ºC for 90min)
    7 Pump room temperature 20 ºF to 122ºF (-5ºC to 55ºC)
    8 Isolation rating between phases 500 V AC
    9 Isolation rating between phases and ground 2.500 V AC
    10 Isolation impedance between phases and ground 2 MΩ
    11 Earthing system TT system (neutral and earht connected separatelly )
    12 Electromagnetic environment CEM-1
  • Nº MEASURING INSTRUMENTS IN THE DISPLAY
    1 System 3 Voltmeter: voltage for every phase R-S-T (RMS)
    2 1 Mains frequency meter
    3 1 pump rotation/phase rotation
    4 1 Manometer pump discharge pressure ( pressure sensor required with 4-20 mA signal)
    5 Jockey pump 1 Ammeter: pump current (RMS)
    6 1 Active power in KW (RMS)
    7 1 Power factor (Cos φ)
    8 Controller 1 Voltmeter: Internal voltage
    9 Controller 1 Voltmeter: back-up battery voltage
  • Nº PUMS & SYSTEM PROTECTION
    1 Voltage loss
    2 Normal power phase reversal
    3 Normal frequency los
    4 Jockey pump protection trip
    5 Thermal overcurrent Jockey pump
    6 Jockey pump fail to start
    7 Low water reservoir tank
    8 Fuses tripped
    9 Controller power loss
  • Nº COMMUNICATIONS & SIGNALS TRANSMISSION
    1 USB Port Boot loader for firmware upgrading
    2 Voltage free contacts : Up to 250 V AC / 2 A Pump running
    3 Grouped alarms